MOTO GUZZI V7 CLASSIC Specifications Page 46

  • Download
  • Add to my manuals
  • Print
  • Page
    / 134
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 45
sensor: on the right cylinder throttle
body
connector: on the potentiometer
Electrical characteristics:
PINS A-C: throttle closed approximately 1.7
kOhm; throttle open approximately 1.1 kOhm.
PINS A-B: approximately 1 kOhm.
Pin-out:
A: ground connection
B: supply voltage +5V
C: potentiometer signal (from 0.5 V with closed
throttle to 4 V with open throttle)
AXONE: PARAMETERS
Potentiometer on throttle / 0.5 (minimum) - 4 (full load)
Correct throttle position / 3.1 (minimum) - 85 (full load)
AXONE: STATUSES
Minimum/full load - ON/OFF
If the throttle is at minimum, it indicates ON, if the throttle is out of minimum, it indicates OFF
AXONE: ELECTRICAL ERRORS
Throttle - open circuit, shorted to positive / shorted to negative.
Error cause
If the circuit is open, shorted to positive: excessive voltage has been detected at PIN 11 of
the control unit connector.
If shorted to negative: voltage equal to zero has been detected.
Troubleshooting
Circuit is open, shorted to positive: check the injection control unit connector and the sensor
connector: if they are not OK, restore; if they are OK, check the continuity between PIN 11
of the control unit connector and PIN C of the sensor (brown/yellow cable): if there is not
continuity, restore the cable harness; if there is continuity, check continuity of the sensor
between PIN A and PIN C: if there is not continuity, replace the potentiometer; if there is
continuity, measure the resistance. If resistance is over 2 kOhm, it indicates the brown/yellow
cable is shorted to positive; therefore, it is necessary to restore cable harness
if shorted to negative: disconnect the sensor connector and check the ground insulation of
the brown/yellow cable (from throttle sensor connector or control unit connector): if there is
continuity with the ground connection, restore the cable harness; if earth insulated, the re-
sistance between PIN A and PIN C is below 1.3 kOhm; therefore, it is necessary to replace
the throttle body.
Electrical system V7 Classic
ELE SYS - 46
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten
Page view 45
1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 133 134

Comments to this Manuals

No comments